I would suggest to put stop loss a few ticks above the hammer bar to be a bit more conservative.
on a 1, 2, or 5 minute chart, places stops a few ticks below the lower of the trigger bar or the prior bar.
That was a Short so...reverse the rule...
the chart image shows the stop up there, above my buddy the fitty, which is one of the "@resistance"s that i love to pair them hammers with, which got the show on the road to start with.
even more conservative,
would be to find a Local low / high in order to have belt and suspenders coverage.
clickin on that chart gets it easier to see.
in the case above, there was nothing else in the neighborhood, and above the fitty was the wrong place to be, so if it went beyond the stop as shown a few ticks above the fitty, then that's what stops are for and get out was in order.
agree with you that a trade like this one allows much less stress, just 'autopilot' with a simple bracket trade using stop and target, set it and forget it. but monitor that baby! lol.
the price for that convenience is that some money is left on the table in this case.
a hand's on trader could mos def yielded more points on this trade, i mean at least down to after the first green bar beyond the low down by the prior swing lowest low at worse, assuming the mid-trade pullback would have been survived or exit and re-entered. But that's a different take and less simple. i like simple. simple is beautiful, lol.
Takin' a chunk outa the middle rinse-and-repeat, beats heavy liftin for the man anyday.
give it a shot an let us know what you think.