You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Simple Profitable Method
- Thread starter trader28
- Start date
- Status
- Not open for further replies.
Quote from trader28:
No problem, but like I said, trade management and a good trading psychology are your responsibility... and those are exactly the factors that send people looking for the next new system that will work, no matter how successful their current one is
Of course. The live call shoulld include the exit. Could you tell us the exact entry? Bar close after crossover or? Also where your stop would be placed? Thx.
Quote from trader28:
Give me a bog simple way to capture an image, the print screen is doing bugger all
Print Scrn should work.
Try these steps (very close to what has already been mentioned).
1) Highlight the window which has the graphic that you want to save. Do this by clicking on it.
2) Press Alt-Print Scrn (holding the Alt key down, press Print Scrn)
3) Start up the Paint program. This is found under Accessories.
4) In Paint go to Edit -> Paste. You should now see the window that you saved.
5) Now save it as a png file on your hard drive.
6) When you write your next message use the Browse button to locate where you saved your png file on your hard drive. This should then upload to ET.
Hopefully these steps will work for you.
Richard
Ok here tis
http://i6.tinypic.com/2m2c3rl.jpg
10 min chart on left for the whole day and 2 min on the right showing the last 3 hours of ER2 trading
10 min MACD below zero all day so apart from a mid day pullback pretty bearish all day
2 min chart starts off with that midday long, MACD crosses it's MA above the Zero Line...
Then there are 4 shorts (all supported by Zero Line) for the rest of the day that all pull roughly $200+ (last one about $150)
Pretty simple stuff, only we can make it complicated
http://i6.tinypic.com/2m2c3rl.jpg
10 min chart on left for the whole day and 2 min on the right showing the last 3 hours of ER2 trading
10 min MACD below zero all day so apart from a mid day pullback pretty bearish all day
2 min chart starts off with that midday long, MACD crosses it's MA above the Zero Line...
Then there are 4 shorts (all supported by Zero Line) for the rest of the day that all pull roughly $200+ (last one about $150)
Pretty simple stuff, only we can make it complicated
Now here is the first half of the day on the 2 minute, notice how even though the MACD crosses it's MA to the upside it never really goes anywhere, because the it is well below the Zero Line and there is no momentum behind it, on the other hand the MA crosses to the downside are all supported by the Zero Line and move well
http://i4.tinypic.com/2dwc6u1.jpg
http://i4.tinypic.com/2dwc6u1.jpg
A system is useless without the exact entry, stop and exit methods. I can show you a thousand crossover charts with great signals if you can just figure out how to weed out the bad ones. I am well aware that the trader ruins most systems but I still challenge you to trade this system live for a couple of days here on ET chat.
Been trading it successfully for ages, entry, stop and exit are pretty damn simple, I use the MA on the price chart to get in as a trade sets up and if it is going to go pear shaped on you then it will break that line significantly, and I go for a set amount within a certain time period, so target or time, whichever comes first... it aint rocket surgery BBQuote from Bearbelly:
A system is useless without the exact entry, stop and exit methods. I can show you a thousand crossover charts with great signals if you can just figure out how to weed out the bad ones. I an\m well aware that the trader ruins most systems but I still challenge you to trade this system live for a couple of days. here on ET chat.
and ps: there wasn't a single bad trade to weed out for the day, and that is a regular occurence... it's as complicated as you want to make it
Thats a question you will have to direct to my wife, the thieving wench... but my specs are pretty impressiveQuote from Thunderdog:
Not that it is relevant to posting a chart (which I also don't know how to do), but why do you not have a printer?
Intel Core 2 Duo E6600 CPU overclocked to 3.2GHz (B2 Stepping, week 26)
WD Raptor 150GB Hard Drive
G.Skill 6400-2GBHZ 2GB RAM
Antec NEO 550W Power Supply
Gigabyte P965-DS3 Motherboard
Nvidia 7900 GT Graphics Card
Creative SB X-FI Sound Card
Benq DW1650 16X DVD Burner
Logitech Z-2300 200W RMS speakers
Dell 2007FP 20.1" LCD Monitor
All running silent with a combination of the right hardware and after market silent component fans and passive heatsinks
I'm a bit of a hardware enthusiast, build all my systems from scratch myself, but Amish when it comes to software, cant stand it
- Status
- Not open for further replies.