ES Journal Archive (2009 - 2010)

Status
Not open for further replies.
Quote from Decel:

All I did was nibble some losses away.

Where to now? To me this area feels like the middle of nowhere.

But huge gap down = 2nd day gap.
huge gap up = short.
....interesting.
More...
Now that you said that, you know the open will not contain a gap, just to keep it interesting. :D
 
Quote from tstones:

But did you find a way to have 1 chart doing RTH, and another one doing globex? They all seem to change together.
More...
I don't see why you couldn't. You just need to open two separate charts with one being the RTH and the other Globex and adjust the timeframe accordingly. With regards to your question, of course once the RTH kicks into high gear, both RTH and Globex will move in tandem. So no separate chart is necessary.
 
I have hourly, 240min, 5min open. I wanted hourly and above to be globex, and 5min to be RTH. But whenever, I change hourly to globex, all 3 charts change to globex.

anyways, probably a question for QT technical support.

Quote from saliva:

I don't see why you couldn't. You just need to open two separate charts with one being the RTH and the other Globex. With regards to your question, of course once the RTH kicks into high gear, both RTH and Globex will move in tandem. So no separate chart is necessary.
More...
 
Quote from volente_00:

Watch for the right shoulder to form in ah to set up the fall below 990.
More...
Nah, tomorrow being the FOMC day, I believe the AH will turn out to be another dead zone. It might even run higher as it always does on the eve of FOMC meetings.
 
Quote from tstones:

I have hourly, 240min, 5min open. I wanted hourly and above to be globex, and 5min to be RTH. But whenever, I change hourly to globex, all 3 charts change to globex.

anyways, probably a question for QT technical support.
More...
Again, you just need to mess around with the timeframe as shown in the chart that I posted above.

The reason why all 3 charts are changing as one of them is changed is because you have them all "linked" together. You'll need to have them run un-synchronized. Make sure the "pushpin" at the top is not depressed.
 
Quote from tstones:

is this 3.9.3a? maybe I'm not using the latest version but my charts were not linked.
More...
Program Version: 3.9.5

I will no longer be fielding any more questions regarding QT since the statute of limitation for Q&A session has expired. (Somebody in fact used that same line of excuse on me earlier in the day so you know where I came up with that idea. :D)
 
Status
Not open for further replies.
Back
Top