Today's whole chart. Carryover is in up sequence at a wait after just assigning T1. Notice how the OB on b78 did not receive the "advance one peak" treatment. B77 wait caused a squish.Therefore the OB is considered a XR instead and makes b78 the first measurable bar possible to assign a first P1 after the PP4 on b76. http://screencast.com/t/yItaS1qPOP3s
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Deciphering Jack Analysis Bar by Bar ll
- Thread starter workwithus
- Start date
BM REV and Ba on b3. http://screencast.com/t/E3MkJIKw2I2
Ok check this out.B4 is a stitch that went higher than the BM on top of b3 but than closes below so no BM REV.Notice this does not allow a RTL to be draw.So this is how a RTL can then not be draw for the rest of this sequence.So i believe you can't have a BO T1 in this sequence. http://screencast.com/t/Hk7c9odp
Another sequence can't draw the rlt. http://screencast.com/t/u307pmYMca5
Thru b26 update.B17 was Bc.PP4 on b19.Ab on b24. PP3 on b26.Don't believe its a BO T1 on b26. http://screencast.com/t/lSrkbsdJ
Can you please spell out the bars that got you to B32 Ab so i know how you got it?B32: Ab ?
thx
Can you please spell out the bars that got you to B32 Ab so i know how you got it?
Having seen your posted no gap chart using Sierra,
I noticed that my NT no gap chart isn't always printing the no gaped bar's highs to lows correctly.
Hence I didn't have a "W" on bar 27 but a P1. and going forward from there,
this led me to an Ab on bar.
many thx
Having seen your posted no gap chart suing Sierra,
I noticed that my NT no gap chart is not always printing the no gaped bar's highs to lows correctly.
Hence I didn't have a "W" on bar 27 but a P1. and going forward from there,
this led me to an Ab on bar.
many thx
Can you post your chart for these bars please.